What Should Be Noted When Using a Fully Automatic Block Making Machine?

Today, Fujian Unik Machinery Technology Co., Ltd. will share some notes about our block making machine. When using a Fully Automatic Block Making Machine, you must keep these precautions in mind—it ensures safety and extends the machine's service life.

First of all, a thorough inspection is a must before starting the machine. Check if all parts of the machine are loose, especially key components like the mold and conveyor belt. Loose screws are a big no-no, as they can easily cause malfunctions. Also, check if there's enough lubricating oil. Running the machine without sufficient oil will wear down the parts, so don't be lazy about this. Besides, take a close look at the electrical circuit and hydraulic system. If there's any damaged wiring or oil leakage, you must fix it first before turning on the machine. Safety always comes first!

There are also tips for operation during the Fully Automatic Block Making Machine's running process. Don't feed too much raw material at once. Overloading the machine with excessive raw material can lead to minor issues like jamming or even major problems such as motor damage—which is definitely not worth it. Keep an eye on the block forming process. If you notice cracks or missing corners on the blocks, stop the machine immediately to adjust the mold or the raw material ratio. Don't wait until a pile of defective blocks is produced before taking action. Additionally, never reach out to touch the moving parts while the machine is running, and keep unauthorized personnel away to prevent accidents.

Daily maintenance is essential after using the machine.

First, clean up any remaining raw material inside the machine, especially the residue in the mold gaps. If you don't clean this, it will affect the quality of the blocks in the next use.

Then, check the parts again and replace any severely worn ones in a timely manner. Finally, cut off the power supply and cover the machine with a dust cover to prevent dust from getting inside and affecting the machine's performance.

One more thing to remind you: it's better for the operator to receive training first. Familiarize yourself with the operating procedures before using the Fully Automatic Block Making Machine. Don't just figure it out by yourself, otherwise, problems will easily occur.